产品描述：

HENRY 523 高弹防水涂料是以优质改性聚合物乳液和水泥为主要原料，添加多种助剂、填充料精致而成的双组份水性防水涂料。防水涂膜拉伸强度高，与基层粘结良好，对于防水膜施工后需粘贴瓷砖，砂浆镘涂的场所特别适用。应用于屋顶、阳台、卫浴、厨房、茶水间、地下室、游泳池、蓄水池、内外墙面等。

 

产品特点：

● 水性环保；

● 防水、透气、耐候性佳；

● 延展性佳，抗基层形变能力强。

 

用法与用量：

1、清理基面，充分润湿基层后施工更佳；

2、将B组份倒入干净的搅拌容器中，然后按照粉液比2:1的比例一边搅拌一边缓慢加入A组份，充分搅拌至色泽一致。

3、用刷子将浆料均匀地涂刷在处理好的基材上，根据使用环境涂刷2层或2层以上。

4、每做完1层，必须待其表干（约1～3小时）后，再做第2层，涂刷方向与第1层垂直。每1层涂刷厚度不超过1mm，以利于固化。

5、涂层施工完后，应自然养护7天。应对防水涂层进行隔离保护，以免破坏。

用量：1.2-1.5kg/m²

 

注意事项：施工环境温度应在5-35℃。阴雨天或基层有明水时不能施工。每次施工需涂布2层以上，应避免漏涂。施工后设备与工具应立即用水清洗。

 

执行标准：GB/T 23445-2009 Ⅱ型

 

储存运输：本品须存放于干燥、通风的室内环境，防潮、防水、防止暴晒，保质期为12个月。

 

包装： 25KG/包，7KG/桶，18KG/桶

 

 

 

HENRY523 High-Flex Waterproof Membrane

 

 

Discription:

HENRY523 is a 2-component waterproof membrane with high quality modified polymer, emulsion, cement, various additives and fillers. The product has high tensile strength and suitable for most substrates, especially suitable for areas to be covered by tiles or mortar. Can be applied on roof, balcony, bathroom, kitchen, tea room, basement, swimming pool, cistern, interior and exterior wall, etc.

 

Features:

Environmental protection, low odor;

Flexible-accommodates normal building movement.

Waterproof, breathable, weather resistance, ultraviolet-proof

 

Application:

1.Prepare the substrate, fully wet surface is more suitable for application.

2. Pour component B liquid into a clean mixer, then slowly add component A powder by mixing ratio of powder: liquid=2:1 while mixing. The mixing time should be 3-5 minutes.

3. Apply the slurry evenly to the substrate with a brush or roller, apply 2 or more layers depending on the condition.

4. The following coat should be applied when the previous coat is slightly dry and solid (but not fully dried). The direction of the following coats should be vertical to the previous one. For easy curing, the thickness of each coat should not over 1mm.

5.After coating application, it should be maintained for 7 days. The site should be isolation protected.

Coverage: 1.0-1.5kg/m2/ layer

Notes:

The application temperature condition should be 5-35℃. application cannot be carried out on rainy days or when there is open water on the substrate. The product should be evenly applied by 2 or more coats. tools should be cleaned by water immediately after application.

 

Standards:GB23445-2009 II

 

Storage& Shelf Life:

This product has a shelf life of approximately 12 months if stored in indoor temperature for 5-35°C in original unopened packaging, avoiding sun exposure or freeze.

 

Package:18 kg/barrel