特点:
● 优异的初粘、终粘强度
● 可适用于多种类弹性地板铺设
● 可用于地板上墙和墙塑粘贴
用途:
● HENRY270多用途超强地板粘合剂用于粘接PVC地板、墙塑、橡胶地材、不透水背衬地毯、石英地板等材料。
● 粘接橡胶地材厚度≤2毫米。
基层处理:
● 基层须具有适当的抗压和抗折强度,表面干燥,没有会影响粘结力的灰尘或污染物。
施工方法:
● 无需稀释、调配,用齿形刮胶板把胶水均匀满涂在施工表面。根据施工现场的气温及湿度,等待约10到20分钟后便可在胶水表面铺上地板,用软木推板压平地板,再用50公斤的滚压器在铺好的地板上滚压可达到更佳效果。
技术参数:
● 颜色: 白色
● Ph值: 7-8
● 密度: 1.4kg/L
● 用量: 200-300g/m2
● 等待时间: 约10 分钟
● 施工时间: 等待时间后约20-30分钟
● 可承重时间: ≥24h
● 终粘强度: 7天
● 能抵受温度: 干固后可承受最高
● 温度至50℃
注意事项:
● 若施工温度低于5℃或湿度高于75%,请咨询本公司技术人员。如产品开封后胶水表面有结膜,需先剔除,搅拌均匀后方可使用。不可直接倒入下水道。用后请将桶盖密封。可用水清洗工具或多余的胶水。
储存方法:
● 本品须存放在室内温度5℃-35℃环境,保质期为12个月。防止冰冻、曝晒。
● 净重:20kg/桶。
Features:
High initial and final adhesion;
Suitable for various resilient floor covering;
Suitable for both floor and wall application.
Uses:
HENRY 270 Multipurpose Floor Adhesive is used for fixing PVC floor, plastic wall sheet, rubber floor (thickness less than 2 mm), impervious backing carpet, quartz floor and other materials.
Substrate Preparation:
The substrate must be mature, sound, solid, clean and dry with good surface integrity.
Mixing and Application:
Fully cover & evenly spread the adhesive over the prepared substrate. Allow the adhesive to ‘set-up/tack-up’ until dry to touch, approx.10-20mins.The set-up time will vary depending on job conditions, substrate, temperature and humidity. Flatten the floor by appropriate tools, and roll the flooring in both directions using a recommended roller (normally 50kg).
Technical Data:
Color:White
PH:7-8
Specific density:1.4kg/L
Consumption:200-300g/m2
Working time:Approx.10 minutes
Set-up time:Approx.20-30minutes
Light traffic:≥24h
Full cure:7days
Temperatures resistance:no more than 50℃ after curing
Attention:
Contact technical team first when the job condition is below 5℃ or above 75%RH. Remove the conjunctival surface first then stir adhesive before use.
Storage:
HENRY 270 has a shelf life of 12 months if kept in a dry store between 5℃ to 35℃. The product shall be stored indoor, protected from frost, kept away from direct sunlight .
Net: 20kg/bucket